CAME VER KIT User Manual download pdf (Page 70)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

9.1.2. Fashioning the Motor Drive Board Power Cable

–

Motor drive board

Black 170 mm

Red 110 mm

Black 22 mm

Toggle switch

–

Heat-shrinkable tubing

Battery snap 1 Battery snap 2

Here we will fashion the motor drive board power cable. Prepare the parts: battery snaps, XH female connector,

pin connectors, toggle switch, 110 mm red electrical wire, 170 mm black electrical wire, and 22 mm black

electrical wire. Make sure to measure the 22 mm piece of wire accurately so that it will be positioned correctly

relative to the battery box. The lengths of the 110 mm and 170 mm pieces of wire need only be accurate to within

a few millimeters. Remove the insulation from both ends of the 22 mm black piece of wire and apply solder to

them as shown in the photo.

Photo 9.28 Photo 9.29

Photo 9.30

As shown in photo 9.30, solder one end of the 22 mm

black wire to battery snap 1.

Photo 9.31

Figure 9.2 (Wiring Diagram)

Red 110 mm

Black 170 mm

Black 22 mm

Battery snap 1

Battery snap 2

Solder the other end of the wire to battery snap 2 as

shown in the photo.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 91 92

No comments

CAME VER KIT User Manual Page 70