CAME VER KIT User Manual download pdf (Page 28)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

4. Drilling and Preparing Holes for Flathead Screws

Before we can proceed with assembly, holes must be drilled in the servo support plate for the toggle switches and

holes in the main board and motor drive board support plate must be prepared for flathead screws.

If no tabletop drill press is available, the tasks in this section can be accomplished using a hand drill.

4.1. Drilling Holes for Toggle Switches

In this section, we will drill mounting holes for the toggle switches in the servo support plate.

Prepare a tabletop drill press as shown in photo 4.1. We

will use a drill bit with a diameter of 6 mm.

(Photo 4.1 shows a tabletop drill with a dia. 6 mm drill

it mounted.

)

Photo 4.1 Photo 4.2

Drilling positions

Photo 4.3

As shown in photo 4.3, hold the servo support plate

firmly in place and align the drill bit with the center of

the hole. Lower the drill slowly.

Photo 4.4

The circles in photo 4.2 indicate the holes that need to be

widened using the drill.

Note: Be careful to make sure you drill in the correct

positions.

Servo support plate

Photo 4.4 shows the servo support plate after drilling

the two holes, completing the task.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 91 92

No comments

CAME VER KIT User Manual Page 28