CAME VER KIT User Manual download pdf (Page 43)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

6.4. Mounting the Front Wheel Shafts

Photo 6.36 Photo 6.37

Photo 6.38

The next task is mounting the front wheel shafts.

As shown in photo 6.37, prepare four each of black

screws, spring washers, and nuts.

As shown in photo 6.38, fit the spring washers over

the black screws.

Photo 6.39

Insert the black screws prepared as shown in photo

6.38 into the assembly from the underside, as shown

in photo 6.39, and screw on nuts loosely to hold them

in place. While pushing on the bearings in the

direction indicated by the arrows (forward and

outward), tighten the nuts securely. While doing this,

be careful to ensure that the left and right shafts

do not make contact in the center. If the shafts

touch in the center, file down the ends some more

to shorten the length.

Front

8 1

Outer

side

Outer

side

The narrower the distance between the end of the

shaft and the notch, the better. However, if you file

off too much the wall of the notch will disappear, and

the E-ring will fall off. If you file off too little, the

opposing shafts will make contact in the center, as

shown in photo 6.40. Try to leave about 1 mm

between the notch and the end of the shaft to ensure

that the opposing shafts do not touch and the E-rings

remain securely in place.

Photo 6.40

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 91 92

No comments

CAME VER KIT User Manual Page 43