CAME VER KIT User Manual download pdf (Page 49)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

Photo 8.6

As shown in photo 8.6, press the shaft into the metal

pinion gear using a small vise, taking care not to

damage the motor terminals. Make sure the motor

shaft is horizontal and take care not to bend it when

operating the vise. During this process, use a piece of

the part frame to check the amount the gear has been

ushed onto the shaft.

Photo 8.7

Note

You must stop closing the vise at a point at which

the shaft is still slightly recessed inside the metal

pinion gear, as shown in photo 8.8. Continuing

until the shaft is flush with the side of the gear or

starts to extend out from the gear would result in

force being applied directly to the shaft, causing it

to bend. This is why you should check your

process using a U-shaped piece of the part

frame.

Photo 8.8

Frame

As indicated by the arrow in photo 8.7, stop closing the

vise at a point right before the gear touches the piece

of the part frame. Now repeat the procedure for the

other motor.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 91 92

No comments

CAME VER KIT User Manual Page 49