CAME VER KIT User Manual download pdf (Page 40)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

6.2. Preparing the Shafts for the Front Wheels

Photo 6.19 Photo 6.20

As shown in photo 6.19, secure the hubs on the wheel

using a total of three sets of screws and nuts. Then repeat

the same procedure for the remaining wheels and hubs.

Photo 6.21

For front wheels

For rear wheels

Remove the bags shown in photo 6.21 from the

high-speed gearbox box. Then remove the shafts from

the bags.

Photo 6.22

Holes

Photo 6.23 Photo 6.24

For this task you will need the two shafts without holes

in them that will be used for the front wheels. Use a

felt-tip pen to make a mark about 1 mm from the notch

indicated by the arrow in photo 6.23.

Clamp the shaft in the vise. Clamping the shaft

directly could damage it, so place pieces of wood or

cardboard between the shaft and the vise.

Notch

The sports tire set includes 16 spare nuts. These nuts

will be used later, so be careful not to lose them.

As shown in photo 6.22, the shafts with holes in them

will be used for the rear wheels, and those without

holes in them will be used for the front wheels.

1 mm

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 91 92

No comments

CAME VER KIT User Manual Page 40