Came BX-243 Kit User Manual download pdf (Page 15)

ENGLISH

The data and information shown in this dialogue may be changed by Came Cancelli Automatici S.p.A. at any time without prior warning.





072

OFF

 

DIP-SWITCH

1 ON - Automatic Closing - The automatic closing timer activates at the end of the opening gate run. The pre-set time is

adjustable, and is in any case conditioned by the activation of any safety devices, and does not activate after a total

safety “stop” or during a blackout.

2 ON - "Open-stop-close-stop" function with [2-7] button and radio transmitter (ﬁ tted with inserted radiofrequency card).

2 OFF - "Open-close" function with [2-7] button and radio transmitter ((ﬁ tted with inserted radiofrequency card).

3 ON - "Open only" function with radio transmitter ((ﬁ tted with inserted radiofrequency card).

4 ON - Pre-Opening and closing ﬂ asher - Following and opening and closing command, the ﬂ asher connected to [10-E1], ﬂ ashes

for 5 seconds before motion begins.

5 ON - Obstacle detected -

When motor is stopped (gate closed or after a total stop command) it prevents any movement if

safety devices, such as photocells, detect any obstacles.

6 ON - Maintained action - The gate works by keeping button pressed (one 2-3P opening button , and one closing button).

7 ON - Functioning of the photocells’ safety test - Allows the card to check the efficiency of any safety devices (i.e. photocells)

after every opening or closing command.

8 OFF - Total stop - This function stops the gate and then excludes any automatic closing cycle; to set in motion again, use

either the keypad or transmitter. Insert the safety device in [1-2]; If unused, set DIP switch to ON

9 OFF - Opening during closing - If the photocells detect an obstacle during gate’s closing, gate motion is inverted until fully

opened; connect the safety device to terminals [2-C1]; if unused, set DIP switch to ON.

10 OFF - Partial stop - Gate stop when obstacle is detected by the safety device; once obstacle is removed, the gate remains still

or closes if automatic closing is activated. Connect the safety device to terminal [2-C3]; if unused, set the DIP switch

to ON

9 Function selector

Default Setting

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

No comments

Came BX-243 Kit User Manual Page 15