Came Krono-S5D Kit User Manual download pdf (Page 28)

5.2 - ZA4 Control Panel Description

Description of Control Panel:

Micro-processor controlled electrical cabinet powered by 230V (a/c) at 50-60Hz, single phase.

Designed for control of CAME (ATI/FERNI/FROG), for hinged gates, hinged industrial doors.

Designed and built entirely by CAME to meet UNI8612 safety standards at an IP 54 level of protection.

Housing made of ABS is equipped with vents to provide internal air circulation. Guaranteed for 3

years, unless tampered with. This control panel is powered 230V a.c across terminals L1 and L2, and

is protected by a 5A fuse on the main power line. Control systems are powered by low voltage and

protected by a 2A fuse. The accessories total wattage (24V) must not exceed 20W.

The control panel and motors should be suitably earthed.

Safety:

SAFETY BEAMS CAN BE CONNECTED TO OBTAIN:

Re-Opening: During closing (2-C1), if the beam is broken while the gate is closing, they will reverse

the direction of movement until the gate is completely open and will stay open until the

obstacle is removed.

Total Stop: (1-2) Creates immediate stop of gate movement without automatic closing: (a

pushbutton or radio remote control must be actuated to resume movement).

N.B IF A NORMALLY CLOSED SAFETY CIRCUIT (2-C1, 1-2) IS OPENED, THE L.E.D

WILL FLASH TO INDICATE THE FACT THAT THE BEAM IS BROKEN.

Accessories that can be Connected to this Unit:

“Gate in Motion” Lamp: The lamp that lights the manoeuvering zone:

it remains lit from the the moment the gate begins to open until they are

completely closed (including the time required for the automatic closure).

When automatic closure is not enabled, the lamp remains lit only during

movement (E-E3).

Other functions available:

Automatic closing: The automatic closing timer is automatically activated at the end of

the opening cycle. The pre-set, adjustable automatic closing time is

automatically interrupted by the activation of any safety system, and

is deactivated after a STOP command or in case of power failure.

“Operator present” function: Gate operates only when the pushbutton is held down (the radio

control system is deactivated)

1 2 ... 23 24 25 26 27 28 29 30 31 32

No comments

Came Krono-S5D Kit User Manual Page 28